Amps
[Top] [All Lists]

[AMPS] B&W 851/852

To: <amps@contesting.com>
Subject: [AMPS] B&W 851/852
From: pgerba@crl.com (Peter Gerba)
Date: Wed, 23 Apr 1997 11:23:40 -0700 (PDT)
Hi Skip;

I'm using an 852 in my 8877 amp (under construction)..B&W says:
2K-4K vdc
out 50-75 ohms
taps..

3.72uh / 268pf
2.34  / 144
1.34  / 73
0.95 / 36

The fellow I spoke to at B&W told me the unit was designed for 2 8877s.

If my data is incorrect (Tom ?) please let me know.

pete, kn6bi


Peter Gerba
pgerba@crl.com

On Wed, 23 Apr 1997, Bob Morris K2RK wrote:

> Skip wrote:
> > 
> > Hello all,
> > I've just found the group here and signed on. I've made some measurements
> > of a B&W 852 coil assembly. Doing the paperwork with some of the values
> > I've measured and the common charts for Pi outputs, I conclude that the
> > values are pretty "general" for the advertised use.
> > 
> > Instead of "tweaking" this one in, it was just easier to machine a new
> > assembly with the proper values for my circuit.
> > Has this been brought up before and have any of you experienced this same
> > issue? Although the unit I have is used, I believe it to be unmodified.
> > 
> > thanks
> > Skip  wv6f
> > 
> > --
> > FAQ on WWW:               http://www.contesting.com/ampfaq.html
> > Submissions:              amps@contesting.com
> > Administrative requests:  amps-REQUEST@contesting.com
> > Problems:                 owner-amps@contesting.com
> 
>      Bill Orr mentions the values in one of the Handbooks, and
> the mods necessary. But just do the math. The listed values (850)
> don't "keep" the same plate impedance for each band. (?). Some were 
> quite far off. As I remember doing it, remove a couple of turns and
> re-tap a couple of bands (Again on an 850).
> 
> --
> FAQ on WWW:               http://www.contesting.com/ampfaq.html
> Submissions:              amps@contesting.com
> Administrative requests:  amps-REQUEST@contesting.com
> Problems:                 owner-amps@contesting.com
> 

--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com

<Prev in Thread] Current Thread [Next in Thread>