Amps
[Top] [All Lists]

[AMPS] Adjusting fil voltage

To: <amps@contesting.com>
Subject: [AMPS] Adjusting fil voltage
From: pmarkham@newsguy.com (pmarkham)
Date: Wed, 20 Jan 1999 08:24:07 -0500


>Actual numerical voltage value is not that important, I just turned it down
>to where power output dropped off and went back up about .1 or .2 volts
>(reading secondard voltage).

?  This is the right way to adj. the fil. potential for a thoriated 
tungsten cathode.  One really doesn't need an accurate fil. voltmeter.  
Howeven, this method can destroy heater/oxide-cathode type tubes.

Can? By what mechanism, if the designed filament voltage is not exceeded?

                         TIA, Pete/wa4hei
  

  The meek will not inherit the Earth. 

--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>