On Mon, 15 Feb 1999 01:36:26 -0500 "Billy W. Cox Jr., AA4NU"
<aa4nu@ix.netcom.com> writes:
>
>Hi !
>
>Moved some things around in the station
>recently, and noticed now that with the amp
>ABOVE the monitor, there is a "ripple"
>or "jumpiness" now when the amp is on.
>
>Any proven "cures" for this ? Amp is an
>AL-1200 and the monitor is a real IBM
>VGA 8513 ... From the bottom of the amp
>to the very top of the monitor case is 2 - 3"...
>
>See many pictures with other setups,
>and their spacing appears to be much
>close than what I am using, so perhaps
>there is an easy/simple solution.
>
>Sorry for such a "basic" question, but I
>know someone else has been down
>this road before ... this should be an
>easy one, compared to the recent topics.
>
>Thanks, and have a great week !
>
>73 Billy AA4NU
Had the same problem here. Moved the monitor and all was fine until I
used the rotator control.
Cure was to use steel shelving to stack gear on since my horizontal real
estate is limited. With the AL-1200, moving the monitor to the right
side may help.
73 Carl KM1H
>--
>FAQ on WWW: http://www.contesting.com/ampfaq.html
>Submissions: amps@contesting.com
>Administrative requests: amps-REQUEST@contesting.com
>Problems: owner-amps@contesting.com
>Search: http://www.contesting.com/km9p/search.htm
>
>
___________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com/getjuno.html
or call Juno at (800) 654-JUNO [654-5866]
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|