Amps
[Top] [All Lists]

[AMPS] Kenwood TL-922A Grid Current

To: <amps@contesting.com>
Subject: [AMPS] Kenwood TL-922A Grid Current
From: KA2YKC@aol.com (KA2YKC@aol.com)
Date: Tue, 2 Mar 1999 23:05:13 EST
In a message dated 3/2/99 10:13:54 PM Eastern Standard Time, km1h@juno.com
writes:

<< >
 >I have changed tubes between three different amps and three different 
 >sets of 3-500Z's and it happens with all tubes.  I am sure the problem 
 >is in the amp.  In addition, I have checked the shunt resistors in the 
 >grid circuit, and they all check good.
 
 What shunt resistors??  In an un -voodooed TL-922 there are no resistors,
 just a pair of grid chokes plus  220pf caps per pin. Those original
 chokes are too big, current and low resistance wise. I suggest replacing
 with something in the 750uh to 1.5mH 160ma and 25 Ohms DC resistance
 range...as used in the SB-220. If there are some strange parts in the
 amp, it might be best to throw them away and follow the original design.
 
  >>
?????

In a factory-stock TL922A there is a 470 ohm resistor in parallel with the
grid choke -actually the resistor is wrapped & soldered to the leads of the
choke. A real pain in the ass to measure each individually during
troubleshooting.

Eric
KK2ED

--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>