Amps
[Top] [All Lists]

[AMPS] amplifier problems

To: <amps@contesting.com>
Subject: [AMPS] amplifier problems
From: mgilmer@gnlp.com (Gilmer, Mike)
Date: Wed, 13 Oct 1999 12:36:46 -0400
On Wednesday, October 13, 1999 12:05 PM, measures
[SMTP:measures@vcnet.com] wrote:
> >
> >On Wednesday, October 13, 1999 10:20 AM, measures
> >[SMTP:measures@vcnet.com] wrote:
> >> >
> >> >Hello all...have an old alpha 374   the resister across the step
down
> >> >relay, a 10 ohm 13 watt wire would burned up....question...can I
> >replace
> >> >this with a 10 ohm 20 watt, what I have available or should I
replace
> >it
> >> >with an exact same wattage???   thanks all   Tim   WB8OWX
> >> >
> >> I have seen ww resistors of the same physical size rated from 10w
to13w. 
> >
> >Your point?
> 
> The ratings game is just that.   13w rated and 10w rated vitreous
coated 
> ww resistors are 2 inches long and 0.4 inches in diameter.  
> >
> >>  A 10w, 10-ohm resistor should probably work ok in this
application.  
> >

It sure gets crowded on a head of a pin.

He has a 20W unit, apparently in hand.  Why would you feel it necessary
to tell him a 10W would work and not answer his specific question and
tell him if a 20W is OK?

> 
> >
> >> However, there is a chance that the resistor was not defective in
the 
> >> first place, and there is a circuit fault which caused the failure.

> >> 
> >
> >True enough, but since a 10W "should probably" maybe it "might not".
> 
> My guess is that a 7-watt rated unit would work in this (intermittent)

> application. 
>

Maybe even smaller. In this application it probably depends more on its
construction than its power rating per se.  I agree the real problem is
why it "broke" in the first place. If being underrated caused the
problem then bigger will be better. If not, then it won't help much -
just cook longer probably.

I'd treat it much like a blown fuse: replace it once and see what
happens - if it blows again, troubleshoot.  Unlike a fuse, it probably
won't "blow" right away even if there's trouble.  So there'll be time to
see (smell?!) if the rest of the circuit is operating properly.


Ciao
Mike
N2MG

--
FAQ on WWW:               http://www.contesting.com/ampsfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>