I wish I had an answer for your second question, Bill. I have tried a
few attempts but I was met with failure each time. I even tried melting
acrylic Plexiglas with chlorinated and non chlorinated solvents but no
avail.
I'm up for suggestions.
Mike(y)
W3SLK
----- Original Message -----
From: Bill Fuqua <wlfuqu00@pop.uky.edu>
To: <amps@contesting.com>
Sent: Sunday, June 11, 2000 5:59 PM
Subject: [AMPS] Two Questions
>
> The first is why do most wide band common cathode triode amplifiers
use
> plate neutralization and not grid? Usually they have a dual capacitor in
> plate circuit and not
> grid. It would be a lot easier to use a balanced grid circuit and a PI
> plate circuit for
> coupling.
> The second is the best way to repair a B&W 850 whose ribs have
> shriveled up and
> disintegrated?
>
> 73
> Bill wa4lav
>
>
> --
> FAQ on WWW: http://www.contesting.com/FAQ/amps
> Submissions: amps@contesting.com
> Administrative requests: amps-REQUEST@contesting.com
> Problems: owner-amps@contesting.com
>
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|