Amps
[Top] [All Lists]

[AMPS] xmfr ratios

To: <amps@contesting.com>
Subject: [AMPS] xmfr ratios
From: nospam4me@juno.com (nospam4me@juno.com)
Date: Sun, 6 May 2001 17:30:41 -0700
-
re: Input xmfr ratios. 
-
Just to throw it out...  one could use an 
xmfr with other ratios.  The 4CX1500B works 
great/better in AB1 apps.  If a low drive exciter is 
used, 9:1 works pretty well.  For some reason, 
one could also use a 2:25 to 1 ratio.  
-
2:25 Doesn't make much sense with AB1 
operation. 
-
For classic 100 plus Amateur Transceivers, one 
would probably set up and use the 12.5 ohms 
value with the belief it's application gives a measure 
of added stability.  (no pun intended) 
- 
Be careful of the extremely low grid diss, it 
doesn't take much to make it go away. After 
long idle periods, I've found at least a 20 min 
warm up helps.  I've got a diagram of the tube 
in an FM broadcast xmtr going up on sonic 
soon. 
-
skipp
-
[snip]
From: measures <2@vc.net>
To: <n4kw@citrus.infi.net>, Subject: Re: [AMPS] 4CX1500B
?  If one uses the Eimac recommended I-limiting shunt type 
screen-regulator, a glitch R in the B+, and adjusts the grid bias V so 
that no more than c. 100uA of grid-I flows under max. drive, there is 
little chance of damage.  An  appropriate grid termination is either 
50-ohms or 12.5-ohms, depending on how much drive is available.  With 
12.5-ohms, a bifilar broadband 4 to 1 xfmr. is needed.  
cheers

________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today!  For your FREE software, visit:
http://dl.www.juno.com/get/tagj.

--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>
  • [AMPS] xmfr ratios, nospam4me@juno.com <=