Billy: thanks ever so much for your msg. on this subject. If you could
answer a couple questions I'd appreciate it. Is this solution not dangerous
to use?? what kind of etch resist material is best with this solution?? OK!!
three questions. what tools do you use to handle the board while etching??
this would appear to be many times better than ferric chloride, but it
also appears to be more dangerous. where does one get ammonium hydroxide and
is it liquid or solid??
thank you for your info on this subject my friend. I've not done much pc
board work because of the hassle with the ferric chloride and the length of
time involved. I am the the world's worst when it comes to this stuff. I was
born and raised with point to point wiring. thanks again for your help.
carl / kz5ca
FAQ on WWW: http://www.contesting.com/FAQ/amps
Administrative requests: amps-REQUEST@contesting.com