Amps
[Top] [All Lists]

[Amps] SB 200 input network rework?

To: <amps@contesting.com>
Subject: [Amps] SB 200 input network rework?
From: dhb@attbi.com (Dave, AA6YQ)
Date: Sat, 1 Jun 2002 16:02:52 -0400
I have an SB221 that was missing a 10m input network; I also wanted 12m and
17m input networks to better match a solid-state driver on those bands. To
get the extra bandswitch positions, I replaced the existing swtich with one
from Surplus Sales of Nebraska. I used the input network design from the
3-500Z amplifier project on page 12.29 of the 1996 ARRL Handbook. This
network uses T-50 toroids, and was easy to adjust for a good match on each
band.

This amp is now at another QTH, and the construction details are a bit hazy.
As I recall, I built the network right behind the front panel to the left of
the meters. If you do this, use a nonmetallic tool and be extraordinarily
careful when adjusting the trimmers, as the HV is nearby.

   73,

      Dave, AA6YQ

-----Original Message-----
From: amps-admin@contesting.com [mailto:amps-admin@contesting.com]On
Behalf Of paule@sfu.ca
Sent: Saturday, June 01, 2002 14:36 PM
To: amps@contesting.com
Subject: [Amps] SB 200 input network rework?


Has anyone reworked the input network to allow it to
be more easily driven by a solid state transciever?

I'm hoping to avoid reinventing the wheel, if
possible?

cheers, Paul - VA7NT ex VE7CQK - email: paule@sfu.ca
"Those who hear not the music. . . think the dancers mad."
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps


<Prev in Thread] Current Thread [Next in Thread>