Amps
[Top] [All Lists]

[Amps] Arcing

To: <amps@contesting.com>
Subject: [Amps] Arcing
From: wc6w at juno.com (Radio WC6W)
Date: Fri Mar 7 19:33:35 2003
On Fri, 7 Mar 2003 13:07:30 -0500 "Tom Rauch" <w8ji@contesting.com>
writes:
> > immediately. The CT was probably about 2ft in diameter and 10" 
> thick, with a ratio of 1200:5.  I was really lucky (blessed) that my
knuckle on 
> the same hand was touching ground, as the voltage was tremendous and I 
> don't think would have survived that potential across my chest.

<snip>

> In your case the current transformer acts like a normal transformer
rather
> than an energy storage system, unless someone broke the line abruptly
at a
> sinewave peak. The problem is you can have considerable voltage drop
across
> the primary impedance, because the primary impedance can be high if the
> secondary is unterminated. With a sinewave signal you could have had
> hundreds of volts across the primary, which would be stepped up to many
> thousands of secondary volts.

Good afternoon Tom & the group,

The same formula works for unterminated secondaries in both transient and
continuous (AC) applications...

V(Secondary) = -M * dI(Primary)/dt      where M is the mutual inductance.

Note:  The derivative of a sine(wave) is...  the cosine

73 & Have a great weekend,
   Marv  WC6W

> As you learned, an open termination on a current transformer can
produce
> some large voltages!! But no more that the turns ratio of the
transformer
> and operating voltage would indicate. A system with an abrupt drop in
> primary excitation, especially if flux density was high, would be a
> different matter.
> 
> 73 Tom
> 

________________________________________________________________
Sign Up for Juno Platinum Internet Access Today
Only $9.95 per month!
Visit www.juno.com
<Prev in Thread] Current Thread [Next in Thread>