One solution it to use a 20v or so, 10A transformer to boost the needed
potential to c. 240v.
>Yes, Dave is right. The laundery machine is connected to a 220v outlet.
>The lower voltage measured is 217 and the highest is 222.
>
>73 Carlos PY4RO
> ----- Original Message -----
> From: Wt8r@aol.com
> To: garyschafer@attbi.com ; carlos.augusto@superig.com.br ;
>amps@contesting.com
> Sent: Monday, April 14, 2003 12:28 AM
> Subject: Re: [Amps] Question about ampifiers
>
>
> In a message dated 4/13/03 10:16:27 PM Eastern Daylight Time,
>garyschafer@attbi.com writes:
>
>
>
> Hi Carlos,
>
> If you are getting your power from a 3 phase line, and you have 120
> volts then there should be only 208 volts across the two phases. I ran
> into that problem at a military installation I was at one time. There
> was no 240 volts to be had. Only 120 and 208 or 3 phase. The amp would
> not work well on the 208.
>
> 73
> Gary K4FMX
>
>
>
> It depends on the configuration of the transformer feed the outlet,
>either "Y" or "Delta". It is conceivable that a small transfomer could be
>obtained to perform the conversion and thereby raised the voltage.
>
> 73 de
>
> Dave, WT8R
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
>
- R. L. Measures, a.k.a. Rich..., 805.386.3734, AG6K,
www.vcnet.com/measures.
end
|