Amps
[Top] [All Lists]

[Amps] Vacuum Relay Contact Bounce

To: <amps@contesting.com>
Subject: [Amps] Vacuum Relay Contact Bounce
From: nospam4me at juno.com (skipp isaham)
Date: Tue Jun 3 08:32:47 2003
Vacuum Relay contact Bounce.
-
A year or two back, I used the RJ1A, the HC-1 and 
a few larger vacuum relays in a research project. 
=
Although these relays established contact transfer 
in the reported < 2ms time, there was considerable 
contact bounce. 
-
Contact bounce made the tested relays unusable 
for at least a few milliseconds. The best I could 
get from the HC-1 was ~4 ms without repeated 
contact bounce.  I consider the 1.5ms speed to 
be a little to optimistic. 
-
cheers
skipp 
- 
--------- Forwarded message ----------
From: "Ian White, G3SEK" <G3SEK@ifwtech.co.uk>


The RJ1A is rated at 8 milliseconds max open or close, and the Kilovac 
HC-1 at 6ms max. The GH1 is rated at 6ms but it doesn't say whether this 
is maximum or typical.

All these figures are when operated from the rated coil voltage, and 
neither speeded-up nor slowed-down electrically.

Rich's highly successful circuit uses a high-voltage supply and a series 
resistor. Recalling earlier posts from Rich, this will speed up typical 
24V relays (RJ1A and HC-1) to about 1.5ms closing. This level of speed 
means that relay closing time is not a significant factor in your QSK 
timing.

However, you don't actually *need* a high voltage supply to achieve this 
speedup. You can do almost the same from the existing relay voltage, by 
using the one-transistor circuit developed by K1KP. Using this circuit 
with the normal 24V rail, I've had 1.5ms closure times from a number of 
HC-1 relays... pretty much the same as Rich gets.

Adding a 'universal' 12V low-current PTT interface to any transceiver, 
the circuit expands to a whole three transistors - see:
http://www.ifwtech.co.uk/g3sek/in-prac/best-of.htm#speedup
Click on the "April 2002" link for more details of how it works.

It's an easy mod to almost any amplifier, and will also speed up an 
existing open-frame antenna relay. Bringing the closure time down from 
about 30ms to more like 15ms can sometimes cure hot-switching problems 
without needing to change the relay.


BTW, my favorite source for vacuum relays is:
http://www.mgs4u.com/relay.htm
Allen Bond is a straight guy, and very easy to deal with.


-- 
73 from Ian G3SEK         'In Practice' columnist for RadCom (RSGB)
                            Editor, 'The VHF/UHF DX Book'
http://www.ifwtech.co.uk/g3sek
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps



________________________________________________________________
The best thing to hit the internet in years - Juno SpeedBand!
Surf the web up to FIVE TIMES FASTER!
Only $14.95/ month - visit www.juno.com to sign up today!
<Prev in Thread] Current Thread [Next in Thread>