*** To tune up a 30L-1 for SSB, apply full drive using high speed dits
to relieve stress on the PS as well as the delicate 811A plates/anodes.
Tune and Load for max relative output. Plate/anode current with dits
should be c. 400mA indicated, which is roughly 800mA peak -- which is
close to the linear-mode emissive limit of 4, 811As. If the indicated
current with dits is over 400mA, less drive is indicated.
have phun, Dan
On Thursday, October 30, 2003, at 11:14 PM, Dan Levin wrote:
I have borrowed a Collins 30L-1 amplifier from a friend for CW SS,
and have a question about tuning it up.
When I tune the amp up according to the instructions, by setting the
Load so
that when I dip the Tune meter of the amp using the Tuning Capacitor
the
Tune meter reads "0" - I get about 300 watts output at the recommended
600 ma of plate current key down CW. Plate voltage is per spec.
If I tune the amp for maximum power output, I tune it with less Load
than
the previous method (the manual's method) would suggest, and I get
about 700 watts of output at 600 ma of plate current. Interestingly,
when
I use this method, the Tuning capacitor ends up in the white range on
the
dial - when I use the manual's method it doesn't always. When I use
this method, the Tune meter reads less than zero.
There is no grid current meter on this amp - so I have no idea how much
grid current I am running in either scenario.
Which method is correct? - where correct is defined as:
1) Maximum power output
2) No damage to the amplifier
3) A clean transmitted signal
Thanks!
***dan, K6IF
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
Rich Measures, AG6K, 805.386.3734. www.somis.org/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|