Amps
[Top] [All Lists]

Re: [Amps] 2x8877 question

To: "Stan C." <kf6ikc@sbcglobal.net>, " AMPS" <amps@contesting.com>
Subject: Re: [Amps] 2x8877 question
From: R.Measures <r@somis.org>
Date: Tue, 30 Mar 2004 05:20:29 -0800
List-post: <mailto:amps@contesting.com>

>Hello gang.
> I have a amp running two (2) 3CX1500A7 tubes. It was built to use on 75m
>AM. Here is the problem. With it keyed....no modulation....the grid
>current is about 40-50 mills. When speaking though the grid current peaks
>to 200+ on voice peaks.

?     200mA of grid-current multiplied by the 8877's  typical
grid-cathode driving potential of 57Vrms = 11.4w of grid dissipation.
The rated grid-dissipation of a pair of 8877s is 50w.  What problem, Stan?

>Using the "load" to bring it down really brings
>down the output. I have ran other amps (Alpha 89,Command 2500E,etc) and
>have had no problem keeping the grid peaks down by advancing the load. But
>only loosing 100-200 watts output. The transmitter is a Johnson Valiant.
> I am wondering if I increase the bias voltage from the current 8.2 to say
>12 or 16 volts if this will help out. I know I will have to drive it a bit
>harder to get a given output with the higher bias voltage,but that is no
>big deal.
> Any help from the knowledgeable would be greatly appreciated.
>
>PS....plate voltage is 3900v under load.
>
>Take care,Stan
>
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>