Amps
[Top] [All Lists]

Re: [Amps] TL-922 Help

To: "Bob Jones" <rfjones@ris.net>, <Amps@contesting.com>
Subject: Re: [Amps] TL-922 Help
From: "Gary Smith" <wa6fgi@sbcglobal.net>
Reply-to: Gary Smith <wa6fgi@sbcglobal.net>
Date: Thu, 24 Feb 2005 10:48:51 -0800
List-post: <mailto:amps@contesting.com>
Did you give the new tube a reasonable amount of time to "cook in ?"
Do recall that rf parts suggests at least 24 hours, did note when I installed 
my new rf parts 3-500, after 24 hours of warming and then putting it to usage 
my output was lower than what I expected.  Then, not expecting, and three week 
later output power had risen to rated amp rf output levels. 
73,
Gary... wa6fgi
  ----- Original Message ----- 
  From: Bob Jones 
  To: Amps@contesting.com 
  Sent: Thursday, February 24, 2005 6:54 AM
  Subject: [Amps] TL-922 Help


  A few quick questions:

  1.In transmit mode with no drive,I have 50ma idle plate current on CW and
  100 ma on SSB.Is this OK and if not how to adjust?Book says should have
  twice this level.Zener checks OK,100 volt supply is OK,both relays check OK.

  2.Using the RF Parts ZG tubes and 80 watts drive I cannot drive the amp to
  full output.I notice SWR on TS-850 is higher than with the Eimac tubes and
  even placed a tuner and different lengths of 50 ohm coax between the 850 and
  amp,this helps but still only 400 ma plate current under full load.Plate
  volts drop from 2000 to 1900 from no load to full load.Ig rarely gets above
  100ma.Have tried tuning input coils using Kenwood method but tuning is very
  broad and has little effect on power out.Any ideas and a safer way to tune
  the input coils?I do have a MFJ Antenna Analyser and thought I could use it
  to look at the coils??
  Note:Amp is running on 220 vac primary power.

  3.Am presently installing Rich measures supressor kit and hope this helps
  the parasitic problem Just lost grid resisters and chokes when one tube went
  cathode to grid short,saved the filament transformer though.

  Any help on item 1 and 2 would be appreciated and I'll have the amp ready to
  put back on the air.

  Thanks and 73,
  Bob
  W0OXJ

  _______________________________________________
  Amps mailing list
  Amps@contesting.com
  http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>