One at work here has rubber bands. O rings should work fine. Just so
they hold tightly enough that the current source isn't making
intermittent contact.
73
John
>Date: Thu, 11 Aug 2005 14:11:46 -0400
>From: "Will Matney" <craxd1@verizon.net>
>Subject: [Amps] Kelvin Clips
>
>I have a set of kelvin clips here for my LCR meter which the rubber
>tubing had went bad and someone replaced it with rubber bands
>wrapped around each before I got them. They work but not as good as
>they should. What type of tubing was that, like the old surgical
>tubing? Also, I was thinking about rubber o-rings, I wonder how they
>would work? These clips new are about $75 a set. There is a cheaper
>set costing about $18 but the jaws are a lot smaller. Has anyone
>used those? I think they may use a coil spring to close them, I'm
>not sure. Any comments are welcome as I'd rather repair these I have
>first.
>
>Best,
>
>Will
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|