Amps
[Top] [All Lists]

Re: [Amps] stepper motors

To: <wc6w@juno.com>, <KD7QAE@ARRL.NET>, <amps@contesting.com>
Subject: Re: [Amps] stepper motors
From: "k7rdx" <k7rdx@charter.net>
Date: Thu, 15 Sep 2005 17:44:01 -0700
List-post: <mailto:amps@contesting.com>
Something Tomm might not know: The Russian vacuum variable caps may have a
diffrent turns ratio(Less turns for more/less C) than other brands like
Jennings,etc.This could affect the final gear ratio used with the stepper
motors.I have a 20-1200pf Russian cap here that requires only 7 or so turns
from low to high C. Jim..
----- Original Message ----- 
From: <wc6w@juno.com>
To: <KD7QAE@ARRL.NET>; <amps@contesting.com>
Sent: Thursday, September 15, 2005 12:34 PM
Subject: Re: [Amps] stepper motors


> Hi Tom,
>   I've commented on this before... don't recall whether in public or
private e-QSO but, ...
>
>   I've built amps with both stepper motors and gearhead motors.  The
gearhead units are easier (less parts) to drive and adapt to autotuning
should it be desired.  Though, I will confess to overcomplicating the
stepper implementation by employing sine drive for quiet operation.
>
> 73 & Good morning,
>   Marv WC6W
>
> -- KD7QAE <KD7QAE@ARRL.NET> wrote:
> I am (still) in the process of designing my dual gs35b amp and would
> like some advice on stepper motor selection.  I have 2 Russian vacuum
> variable caps that I want to motorize and wonder if anyone on the list
> has found just teh right stepper to turn these babys.  the tougher one
> is the 10 to 1200 pF unit.  I can design the controller and drivers and
> will be linking them tothe vacuum relay coil tap selector on the PI
> inductor.  The L section taps are selected by a manual switch which also
> sets the gross tuning position of the capacitors and the proper PI tap
> relay.  I intend on using rotary digital pots to make the fine capacitor
> adjustments from the front panel and then having the option of storing
> the exact setting as read out from shaft encoders for quick setting in a
> particular rig / amp / antenna setup.  Not autotune, but close.
>
> Tomm, KD7QAE
>
> PS, the plate choke is now done, removed 20T from one end and replaced
> w/ 5 wide space helical turns.  I need some power FT caps for the AC
> wiring section to keep RF off the line cord as much as possible, anyone
> got some?
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
>
> ___________________________________________________________________
> Try Juno Platinum for Free! Then, only $9.95/month!
> Unlimited Internet Access with 250MB of Email Storage.
> Visit http://www.juno.com/value to sign up today!
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>