Amps
[Top] [All Lists]

Re: [Amps] [BULK] - One PS, many amps

To: 'W2RU - Bud Hippisley' <W2RU@frontiernet.net>,amps@contesting.com
Subject: Re: [Amps] [BULK] - One PS, many amps
From: Steve Katz <stevek@jmr.com>
Date: Thu, 6 Oct 2005 12:49:13 -0700
List-post: <mailto:amps@contesting.com>
I run multiple RF decks from a common power supply and don't switch anything
except the "amp key" line, and that's only to avoid wasting power dissipated
in tubes that aren't doing any amplifying; I can't understand the need to do
so.  -WB2WIK/6

-----Original Message-----
From: W2RU - Bud Hippisley [mailto:W2RU@frontiernet.net]
Sent: Thursday, October 06, 2005 12:34 PM
To: amps@contesting.com
Subject: [BULK] - [Amps] One PS, many amps


Dino Darling wrote:

>I believe I've read on here before where some owners have built MONO band
amps but powered them all from a single power supply.  So, one power supply
deck and TWO RF decks.  It has been suggested that I use vacuum relays to
switch between the two RF decks.  I was hoping to have them both run in
standby at the same time.  I obviously do not know enough and am therefore
here seeking guidance.  I will only operate one amp at a time.
>  
>
Years -- no, that's not quite right -- decades ago, W1MX used just such 
a system.  We had a bunch of HF monoband push-pull 304TL amplifiers tied 
to a single HV supply.  We had a single Collins exciter.  When we 
changed bands we switched only two functions -- the RG-58 from the 
exciter, and primary power to the 304TL filament transformer in the 
selected amplifier.

So obviously I don't know enough, either, because I'm not understanding 
what the suggested vacuum relays are for.

Bud, W2RU
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>
  • Re: [Amps] [BULK] - One PS, many amps, Steve Katz <=