All,
I have an 8405a with a bad probe. The unit makes it through most of the
calibration until the noise cancellation step. One board works and comes
in at less then 5 mv. However one shows a 1V peak to peak distorted sine
like wave. This probe actually works, however due to the fault it has a
phase frequency error. This error is of course disaster for a phase meter.
Does anyone have experience in diagnosing these probes?
Does anyone have a lead as to what part to suspect?
Thanks - Dan
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|