Amps
[Top] [All Lists]

Re: [Amps] Another use for Neon Lamps

To: "kenw2dtc" <kenw2dtc@comcast.net>, <w6ah@comcast.net>,"Jason Buchanan" <jsb@digistar.com>
Subject: Re: [Amps] Another use for Neon Lamps
From: Bill Turner <dezrat1242@ispwest.com>
Date: Mon, 02 Jan 2006 21:07:06 -0800
List-post: <mailto:amps@contesting.com>
ORIGINAL MESSAGE:

At 08:37 PM 1/2/2006, kenw2dtc wrote:
>My elmer told me that if you put DC source in series with the neon bulb and
>a resistor and set the voltage just below the ignition voltage of the neon,
>it became a more sensitive indicator of RF.  The old guys used "B"
>batteries.  Today one could charge up a decent quality cap and get the same
>result.
>
>73,
>Ken W2DTC


~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

That's a good idea, but remember that when a neon "fires", its 
internal resistance drops. Most likely it would continue to glow even 
after the RF is removed. One way around this is to put a capacitor 
across the neon and a moderately large value resistor in series to 
the DC source. When the neon fires it will discharge the capacitor 
and the large value resistor will take some time to recharge the cap. 
With the right selection of values, you will have a neon that is 
quite sensitive and actually blinks in the presence of RF.

Another thing to try - haven't done it myself - is to raise the 
voltage enough to fire the neon continuously, but use a large series 
resistor so it is very dim (no capacitor). Putting it in an RF field 
would make it glow brighter. Should be very sensitive.

Fun, huh? :-)

73, Bill W6WRT

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>