Amps
[Top] [All Lists]

Re: [Amps] Effects of load Z mismatch?

To: jkearman@att.net (Jim Kearman)
Subject: Re: [Amps] Effects of load Z mismatch?
From: R.Measures <r@somis.org>
Date: Tue, 10 Jan 2006 05:55:47 -0800
List-post: <mailto:amps@contesting.com>
On Jan 9, 2006, at 12:56 PM, Jim Kearman wrote:

>
>> Loading an amplifier heavier than where maximum output occurs helps to
>> keep the operating region in the more linear portion of the load line.
>> In other words heavier loading helps keep the operation down below the
>> upper curve of the load line where flat topping starts to occur, but 
>> at
>> the expense of some efficiency.
>
> Thanks. If I understand correctly, loading more heavily presents a 
> lower impedance to the anode(s), and also incidentally reduces network 
> Q.

**  Q's essentially the same. Jim.  Loading heavier keeps the 
instantaneous anode potential from dipping down into the non-linear 
region of the tube where anode-current is max.  On the characteristic 
curves, this is the area at the left where the flat lines begin to bend 
-- and that's where distortion begins.

> As a CW op, my main concern is efficiency and minimizing harmonics. It 
> was difficult for me to feel confident that I was correctly 
> calculating the required load impedance for my 4CX800As. Now I see 
> that by making the load C large enough, I'll have the flexibility to 
> match a wide range of plate Zs while maintaining adequate network Q. 
> Having enough loading C only becomes a problem on 80 and 160, but this 
> amp will be used only on 160-80-40, so getting those numbers right was 
> critical.
>
> 73,
>
> Jim, KR1S
> http://kr1s.kearman.com/
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>

Richard L. Measures, AG6K, 805.386.3734.  www.somis.org

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>