ok, lets design a hydraulic AMP :)
what kind of "VALVE" will it use? certainly the russians made one!
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com]On
Behalf Of Will Matney
Sent: Thursday, March 16, 2006 11:00 AM
To: amps@contesting.com
Subject: Re: [Amps] Happy birthday to...
Speaking of George, did you know that the same formulas for ohms law, are the
same in hydraulics? The only difference is the terms are changed. Current =
flow, and voltage = pressure. Resistance I'd say is still a resistance like
placing a needle valve in line, or changing a pipe/hose size. I'm not sure what
the term for resistance would be in hydraulics (restriction?) now since I've
not done any of that in probably 7 years? I figure that George seen this in
hydraulics, and converted it over to electricity when he seen they worked the
same. Hydraulics formulas were out way before electrical. The US military used
to teach electronics by using the water theory I think they called it. They
compared how water acted being pumped through pipes as compared to a generator
pushing electrons through a wire, tube = valve, etc..
Best,
Will
*********** REPLY SEPARATOR ***********
On 3/16/06 at 7:40 AM Bill Turner wrote:
>George Ohm, born on this day in 1789, who made it possible for us to
>get in the internet and argue over stuff. :-)
>
>73, Bill W6WRT
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|