Amps
[Top] [All Lists]

Re: [Amps] RE : MW Oven Transformer question

To: amps@contesting.com
Subject: Re: [Amps] RE : MW Oven Transformer question
From: "Will Matney" <craxd1@verizon.net>
Reply-to: craxd1@verizon.net
Date: Wed, 22 Mar 2006 13:50:26 -0500
List-post: <mailto:amps@contesting.com>
What they used to do on oil cooled transformers, is places some thin wood 
strips between each layer making a small windown that the oil could seep 
though. Of course using oil on a regular transformer will only help to a small 
degree, I agree. If the oil can't make it to the mean turns of each winding, 
it's about useless except for keeping the core cooler.

Best,

Will

*********** REPLY SEPARATOR  ***********

On 3/22/06 at 8:50 AM Bill Turner wrote:

>ORIGINAL MESSAGE:
>
>At 04:35 AM 3/22/2006, Larry Carman wrote:
>
>>Not to drift off the subject too much, but I've heard that some hams many
>>years ago would drop there amp's HV transformers in a bucket of oil and
>run
>>the heck out of them, much over there rated current. Anyone out there ever
>>done that?
>
>*********** REPLY SEPARATOR ***********
>
>I'm sure this will increase the transformer's power rating some, but 
>the problem is the oil can only remove heat from the outside of the 
>unit, not from deep inside. That's where overheating would occur 
>first. Heat transfer from the inside to the outside is slow and a 
>surge might do you in. Also, the oil itself would have to be cooled 
>if you're going to operate for any length of time.
>
>Better to just get a bigger transformer.
>
>Bill, W6WRT
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps



_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>