Gary Schafer wrote:
> You can look in Bill Orr's handbook and he says you need 13 pf/meter of
> capacitance at the cathode for proper operation. That's 1040pf on 80 meters.
>
> Then figure out what L network values are needed to match the particular
> tubes input impedance to your 50 ohm driver. In most cases you will find the
> capacitance will fall short of the 13 pf/ meter value.
>
> Here is a handy calculator to do it.
>
> http://bwrc.eecs.berkeley.edu/Research/RF/projects/60GHz/matching/ImpMatch.h
> tml
>
> 73
> Gary K4FMX
I just typed a msg to George, K6GT, and it occurred to me that an L net
will not match 50 ohms to 50 ohms. It would seem to me that, if at some
frequency/loading combination your amp looked like 50 ohms, the LDG
tuner would go into bypass mode and you would have nothing on the
cathode side.
Don't get me wrong, I think that this is a terrific idea but LDG needs
to go one step further and use the freq determining circuit to switch
in the proper input capacitors to give an appropriate Q.
73, Roger
--
Remember the USS Liberty (AGTR-5)
http://ussliberty.org/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|