Amps
[Top] [All Lists]

Re: [Amps] automatical blower speed regulation

To: "'Amps Amps'" <amps@contesting.com>
Subject: Re: [Amps] automatical blower speed regulation
From: "Robert Bonner" <rbonner@qro.com>
Reply-to: rbonner@qro.com
Date: Tue, 22 May 2007 07:11:52 -0500
List-post: <mailto:amps@contesting.com>
Yeah, ALPHA did it on the Alpha 77 in 1977...

They used a 50V bucking winding in the main power transformer running the
blower at 75V and as the thing loaded down the voltage would drop speeding
up the blower.  It worked just fine, if you threw a carrier you could hear
the blower spinning up.

I wouldn't put anything in the main primary winding to effect the line
voltage.  Every watt to me is like gold and loading down the HV is against
my religion.  Total sacrilege. 

BOB DD

-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of Angel Vilaseca
Sent: Tuesday, May 22, 2007 12:27 AM
To: amps@contesting.com
Subject: [Amps] automatical blower speed regulation

Hi all,

To automatically regulate blower speed, how about the following:

Assume you have a 30 W, 110 V blower.

Wire a 110 V - 6 volt  30 VA transformer secondary in series with the HV 
primary transformer.

The HV transformer is many times larger than the 6 V one. Thus the 
current through the 6 volt winding will be highest when the amp is 
working at maximum power and lowest when the amp is idling. The loss of 
HV should be minimal. About 6 %.

Connect the blower to the 110v - 6 volt transformer primary. Voila.

The 6 Volt winding should have a few turns added/removed in order to 
have 110 V at the blower when the amp is working at maximal output.

Anyone already tried this?

Vy 73 de HB9SLV



_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps



_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>