WOW, Water cooling. On a 4 MRF-154 amp you would have the Mister Coffee
Attachment.
OVER
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of Steve Thompson
Sent: Thursday, May 24, 2007 10:23 AM
To: amps@contesting.com
Subject: Re: [Amps] attaching a heat spreader to a heat sink
Robert Bonner wrote:
> You cannot have a heatsink flat enough, and the spreader thick enough. If
> you could build the whole heatsink out of copper you'd be the real stud.
> You couldn't stand the smell of the hot raw copper though. YUK.
There's always water cooling - solder some tubes onto the underside of
the heat spreader (before you do the final flattening). No need for
fancy pure water.
I've always wanted to try soldering a large coffee canister onto the
spreader, mount the amp upside down and fill the can with water. If the
diameter is large enough convection should avoid hotspots boiling.
Steve
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|