Amps
[Top] [All Lists]

Re: [Amps] Output Coupling Capacitors: Failure Mode?

To: "EP Swynar" <gswynar@durham.net>, <amps@contesting.com>
Subject: Re: [Amps] Output Coupling Capacitors: Failure Mode?
From: "jeremy-ca" <km1h@jeremy.mv.com>
Date: Wed, 31 Oct 2007 14:13:48 -0400
List-post: <mailto:amps@contesting.com>
If the fixed caps for 160 arent overheating then they are a real long shot.

How about the plate choke? Is it sufficient L for 160, does it look damaged? 
Same for the choke bypass cap.

What type of input are you using? A saturated GG filament choke, or bad 
input network coil or cap would be band specific items to look for.

Carl
KM1H


----- Original Message ----- 
From: "EP Swynar" <gswynar@durham.net>
To: <amps@contesting.com>
Sent: Wednesday, October 31, 2007 2:02 PM
Subject: [Amps] Output Coupling Capacitors: Failure Mode?


> Good Afternoon All,
>
> A few weeks ago there was a thread meandering its way through the 
> reflector re. the failure mode of the output coupling capacitor in linear 
> amplifiers --- I wish that I'd paid better attention, as I suspect my 
> coupling cap here is entering the proverbial "...zone of no return" 
> here...
>
> Specifically, when I make a long transmission on 160-meters, the RF output 
> from my 2x813 kilowatt starts to creep downward. To-day I took the top 
> cover off the amplifier, and fired-up into a Heath Cantenna. The output 
> dropped RAPIDLY as I keyed the rig on & off, ending-up at just over 
> 100-watts in a few minutes!
>
> Re-peaking the plate tuning capacitor helps some --- adding more "C" at 
> the plate loading capacitor helps some, too...but it's all short-lived. In 
> no time at all, RF drops again.
>
> I've felt the door knob output coupling capacitor for excessive heat (with 
> the B+ off, of course!), but it feels normal. I've substituted the plate 
> tuning buffer capacitor with another similar fixed vacuum unit, with no 
> difference. Ditto the buffer cap for the loading side.
>
> Interestingly enough, the rig puts out a healthy, steady, 600-plus watts 
> on other bands --- the problem seems limited to 160 (my favourite one, of 
> course!).
>
> Can output coupling caps go south like this, but on a frequency / 
> band-specific basis...? My next step is to replace mine with a 10KV glass 
> capacitor (0.002-ufd.), but it's gonna be tricky getting that deep inside 
> the bowels of this thing!
>
> Any & all thoughts appreciated, with thanks in advance...
>
> ~73!~ Eddy VE3CUI - VE3XZ
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> 

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>