Amps
[Top] [All Lists]

Re: [Amps] How to ID a swinging choke?

To: "jeremy-ca" <km1h@jeremy.mv.com>, <amps@contesting.com>
Subject: Re: [Amps] How to ID a swinging choke?
From: "k7fm" <k7fm@teleport.com>
Reply-to: k7fm <k7fm@teleport.com>
Date: Sat, 8 Dec 2007 06:46:54 -0800
List-post: <mailto:amps@contesting.com>
"Is there a simple bench test or an eyeball way to tell the difference 
between a fixed and swinging choke?"

The eyeball test involves looking to see if there is a rope or chain holding 
it up.  If there is, hold your head stationary and watch to see if the choke 
moves.  If it moves, it is a swinging choke.  If there is no rope or chain 
and it does not move, it is fixed.  This test does not apply on shipboard.

73,  Colin  K7FM

Since the inductance of a swinging choke varies with current, I think you 
will find that if you measure the inductance with no current flowing, you 
will find an inductance much higher than the standard smoothing choke.  So, 
if you use an inductance meter, and measure much more than 8 hy, I would 
suspect a swinging choke.

The swinging choke has an air gap.  Well, actually it is a non-conducting 
gap in the core.  It can be brass or bakelite.  Also, the insulation is much 
greater, because the peak voltage can be much higher.

You should be able to actually test the choke at very low voltage (under 10 
volts) and get useful results by varying the current through it. 

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>