[Top] [All Lists]

Re: [Amps] 1/4" shaft connectors

Subject: Re: [Amps] 1/4" shaft connectors
From: Robert Morris <>
Date: Sat, 27 Sep 2008 01:06:38 -0400
List-post: <">>
No one said they have to be round. I used 1/2" square stock, cut off an 
inch, drilled a 1/4" hole, tapped for the 6-32 screws.

Glen Zook wrote:
> Frankly, you can make you own couplers for just a few cents each from copper 
> tubing that has an inside diameter of 1/4 inch.  Cut off a length about 1 
> inch long and then drill a hole near each end.  Then "tap" that hole for a 
> machine screw.
> Now you will need a tubing cutter which is just a few dollars at any home 
> improvement center, a drill and bit, and a tap.  However, these tools are 
> already in the possession of just about any amateur radio operator who does 
> any building at all.
> Glen, K9STH
> Website:
> _______________________________________________
> Amps mailing list

This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.

Amps mailing list

<Prev in Thread] Current Thread [Next in Thread>