I second this. In fact, Don may be a little modest here. Scrubbing
Bubbles is the best all purpose cleaner for PCB boards and electronic
assemblies I've ever found in 20+ years of fooling around with
electronics.
It will cut dried, sticky Coca-Cola residue, for example. It's what I
used to use to repair TV remotes that went for a swim in somebody's
drink. Spray the board down in the sink, leave it for a few minutes,
come back and rinse it off with tap water. Place the now-clean board
in the sunshine or dry thoroughly with a hair dryer and you're good to
go.
People don't think about it, but modern electronic parts are
water-tight. You're not going to drown a transistor.
Jeff/KD4RBG
---- Original message ----
>Date: Fri, 31 Jul 2009 22:30:54 -0500
>From: donroden@hiwaay.net
>Subject: Re: [Amps] Cleaning Cigarette tar....?
>To: amps@contesting.com
>
>Scrubbing Bubbles works wonders on Commercial Broadcast transmitters
>that have been in harsh environments... Melts the dirt right off.
>
>Don WA4NPL
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|