You should really see 0uA. Run it through its range and stop on the positions
that have leakage. Drop it to 4 KV and let it cook. You might be able to
effect a repair if it is gas as the arc will getter to some extent or the arc
may help clear the leakage path. It could very well make it worse. You have
nothing to lose at this point.
Randy AB9GO
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of Steve
Sent: Friday, September 18, 2009 7:03 AM
To: amps@contesting.com
Subject: [Amps] Vacuum variable hipot
I have a Jennings UCSL1000 - 1000pF, 5kV cap. If I put 5kV dc across it
and run it through its tuning range, the leakage current is sometimes
zero but fluctuates and there are places where the current leaps up to
50uA. At those points the current falls to zero if the voltage is
reduced to around 4kV, although I have heard a couple of arc 'pops' from
it sitting there at 4kV.
At other settings where the current is lower, 5uA or less, the leakage
dies away to zero if I leave it sitting there for a while.
Is this normal behaviour? Is this one a duffer?
Thanks,
Steve
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
Confidentiality Notice: This e-mail message, including any attachments, is for
the sole use of the intended recipient(s) and may contain confidential and
privileged information. Any unauthorized review, use, disclosure or
distribution is prohibited. If you are not the intended recipient, please
contact the sender by reply e-mail and destroy all copies of the original
message.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|