You can use the MHV type coax connector. Looks like a BNC on steroids.
I used them to power an IR Image Converter that required 8 kVDC many
moons ago.
73, Dick, W1KSZ
> Date: Tue, 12 Jan 2010 20:17:40 -0800
> From: audioguy@charter.net
> CC: Amps@contesting.com
> Subject: Re: [Amps] which HV connector to use?
>
> Assuming one doesn't insist on using the Millen connectors, what's a
> good alternative?
>
> Someone mentioned RG-214 a few pages back but having been there, done
> that and arced most of the common connectors I'm not thrilled with that
> one either.
>
> Perhaps the moral is to always build integrated. (and buy bigger desks...)
>
> 73,
> Jim, N7CXI
>
> Phil Clements wrote:
> >
> >
> >> The Millen has a known history of flashing to a metal mounting at 5Kv once
> >> they have absorbed sufficient moisture even in clean holes. I quit selling
> >> them due to failures and complaints.
> >>
> >> Carl
> >> KM1H
> >
> > Amen, Carl. If one insists upon using the Millen red and blacks, I suggest
> > my method of punching a one and 1/4 inch round hole in the chassis, mounting
> > a 2 X 2 X 1/2 inch piece of Plexiglas behind the hole, and installing the
> > connector in the center of the round hole backed up by the Plexiglas. I have
> > used this successfully on 6 KV supplies with no problems. I would never use
> > the Millen connectors without the plastic backing at voltages over 3 KV.
> > There is a yellow Millen connector that absorbs moisture worse than the red
> > and black!
> >
> > (((73)))
> > Phil, K5PC
> >
> >
> >
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
> >
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|