Amps
[Top] [All Lists]

Re: [Amps] shorted filter cap

Subject: Re: [Amps] shorted filter cap
From: Jim Barber <audioguy@charter.net>
Reply-to: audioguy@charter.net
Date: Fri, 12 Feb 2010 14:50:09 -0800
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Semantics.
If it goes 'bang' and causes me to claw the ceiling, then that's close 
enough to shorted for me, although in the heat of the moment I might 
choose expletives over adjectives...

73,
Jim, N7CXI


Bill, W6WRT wrote:
> ORIGINAL MESSAGE:
> 
> On Fri, 12 Feb 2010 09:01:58 -0600, "Danny Pease" <dpease@adams.net>
> wrote:
> 
>> Shorted is relative. If you can measure low enough, there is no such thing
>> as a short. A piece of wire is usually considered a short, but we all know
>> it has some values of resistance. A few ohms compared to a several hundred
>> thousand or even millions, is a short.
> 
> REPLY:
> 
> Correct, in the theoretical sense.
> 
>  In the practical sense, anyone who has been troubleshooting long
> knows the difference between a shorted part and one that is leaky, and
> that is the sense in which I was speaking.  
> 
> 73, Bill W6WRT
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> 
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>