[Top] [All Lists]

Re: [Amps] Transformer E-I lamination sources?

Subject: Re: [Amps] Transformer E-I lamination sources?
Date: Thu, 20 May 2010 15:52:07 EDT
List-post: <">>
In a message dated 5/20/2010 12:41:18 P.M.  Eastern Daylight Time, writes:

I've been searching  the Internet for suppliers of transformer E-I 
laminations. I've found a few,  but their web sites are difficult to 
navigate and I never did find the  specific laminations I wanted. That 
and most of them are off shore  industrial suppliers and I don't really 
need a couple tons of the  stuff.<:-))


Roger (K8RI)

What sizes you  are looking for?
I assume you want to build a power transformer?

I  have had good dealings with Lamination Specialties Corp.
in Chicago,  IL

They are very friendly and will accept small orders but 
they do  have a minimum order size of 1/2 string which is 
660 sets of EI lams.  

I bought a half-string of EI-175 lams from them about a year 
ago (  45lbs worth ) + UPS Ground shipping for $177. The price
on steel changes all  the time so they will give you a current

You can reach them at  : 

Also depending on what you want  to build you may need some
Plastic Bobbins to fit, L-Brackets or Keeper Lams  which I got

73 Todd WD4NGG  

Amps mailing list

<Prev in Thread] Current Thread [Next in Thread>