Amps
[Top] [All Lists]

Re: [Amps] Glass tube plate color

To: Barrie Smith <barrie@centric.net>, "amps@contesting.com" <amps@contesting.com>
Subject: Re: [Amps] Glass tube plate color
From: "Fuqua, Bill L" <wlfuqu00@uky.edu>
Date: Sun, 15 Aug 2010 13:10:42 -0400
List-post: <amps@contesting.com">mailto:amps@contesting.com>
  These tubes were never intended to be used as amplifier but in stripline 
oscillators, either single tube or push-pull.
There were no real efforts to match them. In oscillators you want low mu so 
that they will draw lots of plate current to 
get started quickly. I seem to recall the plate dissipation was 200 Watts with 
a very bright glow.  These tubes were driven hard is early
radar and radar jammers.  Often pulsed. Hams used to use them because they were 
very cheap on the surplus market.
  EIMAC even made a version with a glass tube attached to it (about 1/2" ID) 
and no vacuum inside to be used as a ion vacuum guage tube. 

73
Bill 
________________________________________
From: amps-bounces@contesting.com [amps-bounces@contesting.com] On Behalf Of 
Barrie Smith [barrie@centric.net]
Sent: Sunday, August 15, 2010 12:52 PM
To: amps@contesting.com
Subject: Re: [Amps] Glass tube plate color

Damit, Carl, that's a good question!  I'll try that right away.

Barrie

----- Original Message -----
From: "Carl" <km1h@jeremy.mv.com>
To: "Barrie Smith" <barrie@centric.net>; <amps@contesting.com>
Sent: Sunday, August 15, 2010 10:45 AM
Subject: Re: [Amps] Glass tube plate color


> What happens when you swap positions?
>
> Carl
>
>
> ----- Original Message -----
> From: "Barrie Smith" <barrie@centric.net>
> To: <amps@contesting.com>
> Sent: Sunday, August 15, 2010 11:55 AM
> Subject: [Amps] Glass tube plate color
>
>
>> Speaking of class C, I have just completed a nostalgia rig using a
>> push-pull pair of VT-127As (somewhat similar to the 100TL, but looks like
>> a spaceman with grid and plate pins sticking out the sides).
>>
>> I've been bench-testing it the last few days with a wimpy power supply.
>> Surprisingly, I'm up to 500 wattts out with 1300 volts on the plates.
>>
>> I have several tubes, and have tried a couple of different pairs.  In
>> both instances I've noticed that one tube will have a slightly brighter
>> plate glow than the other.
>>
>> I'd like to have the tubes as closely matched as possible.
>>
>> My question is:  Which tube is most likely to be the better, the bright
>> one, or the cooler one?
>>
>> 73,
>> Barrie, W7ALW, DN36au,
>> QRV 6M, 432 & 1296 EME
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>
>
>



_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>