Amps
[Top] [All Lists]

Re: [Amps] Cathode input circuit

To: "Mike Lord" <k4elv@bellsouth.net>, <amps@contesting.com>
Subject: Re: [Amps] Cathode input circuit
From: "Carl" <km1h@jeremy.mv.com>
Date: Mon, 1 Nov 2010 17:49:22 -0400
List-post: <amps@contesting.com">mailto:amps@contesting.com>
That circuit goes back to the early days of SSB linears and is in QST, HB, 
and possibly the early edition SSB Manuals

Carl
KM1H



----- Original Message ----- 
From: "Mike Lord" <k4elv@bellsouth.net>
To: <amps@contesting.com>
Sent: Monday, November 01, 2010 10:28 AM
Subject: [Amps] Cathode input circuit


>A question for the group.  Some time back, ZL1AXB published a circuit for a 
>single 813 grounded grid, using a tuned coil input circuit.  He referred to 
>it as a "bifilar wound coil."   I built the amp and it works like a champ. 
>The only other reference to this tuned input I could find was in Orr's 18th 
>edition where he used it on a 6 meter amp. (pp 747 -749).  I couldn't find 
>any further discussion by Orr.  Pat's circuit covered 40 - 10 meters.  I 
>would like to use this circuit on 80 and 160.  Is there a formula for 
>winding the coil?  As anyone else had experience with this tuned input? 
>Thanks.  Mike K4ELV
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps 

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>