I would agree to keep the anodization and use star type lock washers that will
dig thru to get good electrical contact unless the anodization is PINK.
Then you may reconsider.
73
Bill wa4lav
________________________________________
From: amps-bounces@contesting.com [amps-bounces@contesting.com] On Behalf Of
Ken [n4zed@comcast.net]
Sent: Monday, October 17, 2011 8:41 PM
To: amps@contesting.com
Subject: Re: [Amps] Anodised aluminum
Yes you can. I would use star or lock washers and NOT remove any anodize if
at all possible.
Ken
N4zed
----- Original Message -----
From: "Robert Briggs" <vk3zl@bigpond.com>
To: <amps@contesting.com>
Sent: Monday, October 17, 2011 6:53 AM
Subject: [Amps] Anodised aluminum
>
>
> Hi all...I have just aquired a quantity of 2mm anodised aluminum sheet,,
> I am wondering if I remove the anodising from all contact surfaces if I
> can use this stock for rf deck cases...
>
> Cheers all....Bob..VK3ZL..
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|