What HB9SLV suggested was not exactly an ArytonPerry winding, although the
principle is
the same. Instead of being in parallel, his idea had the windings in series. So
they will
always carry the same current!
On 2/5/2012 9:23 AM, jeff millar wrote:
> Interesting... I looked up ArytonPerry winding as a result. The Wikipedia
> entry pointed out ...
>
> "One disadvantage is that because the two lengths of resistive wire are
> connected in parallel, four times the length of wire (twice the length for
> each coil) is needed to make a given resistance than if a single coil was
> used."
>
> That led to the realization that the two windings have to carry the same
> current
> to have the magnetic fields cancel...which means they have to have the same
> resistance.
>
> Conclusions...
>  start with 100 Ohm wire wound resistor
>  count the turns
>  wind 100 Ohms worth of copper over the same length
>  for same turn count, need smaller diameter wire
>
> jeff, wa1hco
>
> On 02/03/2012 03:23 AM, Angel Vilaseca wrote:
>> Hi all
>>
>> I have a nice large 50 ohms wirewound resistor, which I would like to
>> use as a dummy load. Problem is, it is inductive of course.
>>
>> To cancel the inductive reactance I was thinking of winding some
>> enameled wire all along over the resistor, with as many turns as the
>> resistive wire, solder the enameled wire to the resistor terminal at one
>> end and feed the RF at the other two separate terminals (wire and
>> resistor) at the other end.
>>
>> The idea is that the inductive reactance of the resistor winding and the
>> enameled wire winding will cancel each other. With some care and
>> measuring gear the remaining reactance could be very low. The assembly
>> would then behave almost as a pure resistance.
>>
>> Of course, care should be taken not to reach too high temperatures,
>> because the enameled wire would then be damaged.
>>
>> Also, the added winding should be wound in the appropriate diraction (
>> CW or CCW depending of the winding direction of the resistive wire)
>> otherwise the two inductances would add instead ao canceling each other.
>>
>> Has anyone alredy tried this?
>>
>> 73
>>
>> Angel Vilaseca HB9SLV
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps

Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
