Why don’t you want to float the ground?
It's easy to protect circuitry with a properly connected diode along with
the resistor between B- and ground.
Enlighten us please Charlie.
73
Jim W7RY
-----Original Message-----
From: Charlie
Sent: Tuesday, November 10, 2015 6:33 PM
To: amps@contesting.com
Subject: [Amps] Measuring Grid Current in GG Amp
Folks-
In a GG amp, suggestions on how to measure Grid current WITHOUT the typical
semi-floating B-.
Using a SMPS. Plate current and Voltage are present as 0-5 volt full scale.
1) Measure Cathode current across Rk, and subtract Cathode I from
Plate I in an op amp to derive Grid I?
2) Untie the grid from physical ground, RF ground with caps, measure
Grid I across a small resistor?
3) ?
Thanks for flexing the gray matter.
73 Charlie N6CFH
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|