The ceramic chimneys of GU-43B tubes fit very well.
http://www.ebay.de/itm/Keramik-Kamin-fur-GU43-Rohrenfassung-/131961345338?ha
sh=item1eb982553a:g:TdsAAOSwujFXF-vq
73
Peter
-----Original Message-----
From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of N1BUG
Sent: Montag, 31. Oktober 2016 16:41
To: amps@contesting.com
Subject: Re: [Amps] Chimney for GS35B
On 10/31/2016 04:10 AM, Roger (K8RI) wrote:
> Gerald already mentioned using Teflon sheet. I'd use high temp epoxy or
> glue instead of screws. I don't like electrical conductors sticking
> through insulating material.
I use Teflon sheet and nylon machine screws and lock nuts. Initially
I was concerned about heat with the nylon hardware but I have not
had any problems. Here is a chimney for a 4CX1500B which has been in
service for 15 years at 1500 watts out, including high duty cycle modes:
http://n1bug.com/chimney.jpg
73,
Paul N1BUG
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|
