Ive used the 4600Z as a replacement in several amps and dont find it
objectionable but a resistor could be used to slow it down or use a switch
for two speeds as I did to my Amp Supply LK-500ZC.
Carl
----- Original Message -----
From: "Zev Darack" <zevdarack@gmail.com>
To: "john shea" <w3khg@triad.rr.com>
Cc: "amps" <amps@contesting.com>
Sent: Thursday, January 11, 2018 3:25 PM
Subject: Re: [Amps] Need Fan for amp
I put in an ebm papst 4600z into mine. I don't find it particularly
quiet....has too much of a high pitched wine on high speed for my liking
but it works....specs say 45dba
Look at the dimensions and the CFM 119x119x38mm 106cfm 115v AC.
Note, it was a PITA to put in. I had to take out the transformer and I
think the RF deck holding the tubes had to be unscrewed to get to the
screws holding the fan in place.
I just wish I put in a temperature sensor that auto controlled the
speed.....
73,
Zev N2WKS
On Tue, Jan 9, 2018 at 11:19 AM, john shea <w3khg@triad.rr.com> wrote:
Newly acquired thirty year old Amp International LK500-ZC original
cooling
fan is noisy. Fan works very well except for the noise which occurs after
the first 4 minutes. Is there a source for replacements or someone who
specializes in rebuilding these units?
73
john/w3khg
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
---
This email has been checked for viruses by AVG.
http://www.avg.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|