Ok,
Lots of reading, LOTS of help from others here. This should be the last
bit of questions I have the need of help with.
When doing the like reverse plate load simulation test. I have been
told, and have read, both things when doing the test, some have said to
lift the plate connections off the tubes. While others say that they
need to still be connected. So what way is it?
What value of "Q" should one desire to have?
And once the amp is thought of to be set up with that desired value of "Q"
Is there a way to measure this value of "Q"?
Joe WB9SBD
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|