How are you adjusting the phase?
On Tue, Sep 9, 2008 at 3:34 PM, Andrew Ikin <firstname.lastname@example.org>wrote:
> Hello Guys
> Having struggled to model an 3 element endfire Active Vertical array using
> the same Phasing lines from 0.53MHz to 2.12MHz. I find that I can achieve a
> very good elevation plot with very low rear lobes (-30dB). Even the plot at
> 2.65MHz only shows 2 small (-22dB) rear lobes!!! Also this model is very
> tolerant of several dB amplitude difference on the outer elements providing
> that the centre element is the sum of the 2 outer ones.
> I have tried to do the same with the 4 Square, but there is always a large
> rear lobe on the elevation plot 10-15dB higher than the 3 element endfire,
> no matter how I adjust the phase. Am I doing something wrong or is there a
> fundamental problem with the 4 Square?!
> Both arrays have 40m Element spacing.
> Andrew G8LUG (not active)
> Antennaware mailing list
Antennaware mailing list