[Top] [All Lists]

[Antennaware] 160M vertical impedance

To: <>
Subject: [Antennaware] 160M vertical impedance
From: "K9AY" <>
Date: Tue, 3 Mar 2009 16:20:40 -0600
List-post: <">>
I finally took some time to review my modeling vs. measurement of the feed 
impedance of my 160M vertical.

To review -- my original model showed 39.8 +j48 ohms at 1850 kHz, with 8" 
diameter (yes, diameter) used for the 25G. This was a simplified EZNEC model 
for a vertical, with the antenna at ground level, no radials and MININEC 
ground. The modeled reactance is close to the capacitance value I ended up 
with for matching. However, the measured (estimated) resistance was very 
close to 50 ohms, which is a long way from 39.8 ohms.

Since I was unable to make the model match the measurement by adjusting 
conductor sizes and lengths, I focused on my initial suspicion: the ground 
slope. Although EZNEC does not have an easy way to change ground itself, 
this is a system with radials that, hopefully, isolate most of the fields 
from lossy ground, so I did the following:

Used 'High Accuracy' ground, and raised the entire antenna model 12 ft above 
ground. I then let EZNEC create 32 radials based on a prototype 110-ft. 
radial. This appoximates my actual radial system. With these horizontal 
elevated radials, the modeled feed impedance was 40.2 +j37, a reasonable 
match to the original model. Very promising!

I next re-created the radials with the prototype wire sloping from 12 ft. 
down to 1 ft., representing the maximum slope of my terrain. This raised the 
modeled feed resistance from 40.2 ohms to nearly 46 ohms -- more than I 
expected from the fairly shallow slope angle, and much closer to the 
measured impedance.

However, my ground is not uniformly sloped downhill from the tower, so I 
modified the end heights of the radials to approximately match my ground 
contours. About 1/4 of the modified radial system is horizontal, with the 
rest at various downward slopes. But the resistance only dropped to 44.3 
ohms. It appears that even a small amount of slope in the radial system will 
significantly raise the resistance at the feedpoint.

While the method may not be perfect, I am now satisfied that the slope of 
the ground is the primary reason for the difference in resistance.

73, Gary

Antennaware mailing list

<Prev in Thread] Current Thread [Next in Thread>
  • [Antennaware] 160M vertical impedance, K9AY <=