|To:||Ray <email@example.com>, NA Reflector <NA-User@contesting.com>,Yaesu Reflector <firstname.lastname@example.org>|
|Subject:||Re: [NA-User] Interface problem|
|From:||"Bob, N5RP" <email@example.com>|
|Date:||Thu, 11 Dec 2003 07:07:23 -0600|
Now then, my answer may seem strange, but since you can sync by pressing the ALT/F1 or ALT/F2 a couple of times, it would seem that you do not have a problem.
here, on this end, upon start-up, even with all radio station components booted from cold, I do the ALT/F1 and ALT/F2, as well - not to sync perhaps, but to check and insure proper interface relationships.
So you and I perform the same function activities, and achieve the same results.
You see a problem, I do not see a problem.
I hope I was properly polite in the tone of my reply.
73, Bob - N5RP ====================================== At 23:58 12/10/2003, Ray wrote:
I am having a problem that occurs when I turn off my FT1000MP that is interfaced to NA logging software. I keep the computer running since it is my interface to Packet. Later, when I turn on the FT1000MP, the software does not sync with the band & mode displayed on NA. The CAT LED does flash as it should.
_______________________________________________ NA-User mailing list NA-User@contesting.com http://lists.contesting.com/mailman/listinfo/na-user NA on the web: http://www.datomonline.com/
|<Prev in Thread]||Current Thread||[Next in Thread>|