Gary "Joe" Mayfield wrote:
> I guess I will reply to the group. If I had a vet I would go with one of
> these solutions.
>
> http://www.licenseplateantenna.com/
>
Talk about spin. the antennas they were describing as causing problems
or being recognizable look exactly like satellite radio, cell phone, or
ham antennas which are all very common here in the state of Michigan.
73
Roger (K8RI)
> 73,
> Joe kk0sd
>
> -----Original Message-----
> From: rfi-bounces@contesting.com [mailto:rfi-bounces@contesting.com] On
> Behalf Of Gary Smith
> Sent: Monday, January 18, 2010 12:49 PM
> To: Dale Martin; 'RFI'
> Subject: Re: [RFI] WAY OT
>
> Hi Dale.
> I would suggest a small sheet of copper screening. Its easier to deal with
> and you can epoxy it to the underside of the car body where the antenna will
> be positioned.
> A suggestion: site where you might want the hole for the mount to go, then
> look underneath that are to see it is in an area that is practical to apply
> the screen. If so, drill the hole and then put the screen in place allowing
> some of the mesh to be attached to the antenna mount.
> Last but not least, ping GM in Bowling Green and ask them where the *best*
> place for a antenna might be.
> Am confident they have had this question put to them before. .50 worth on
> this,
> Gary...wa6fgi
> ----- Original Message -----
> From: Dale Martin
> To: 'RFI'
> Sent: Monday, January 18, 2010 9:04 AM
> Subject: Re: [RFI] WAY OT
>
>
>
>
> I haven't had any experience with fiberglass body installs, but what about
> a
> simple lip mount to the trunk lid with a strip of metal plate for
> reinforcement?
>
> If the antenna doesn't perform well without a ground plane, attach
> grounded
> sheet of aluminum or copper to the inside of the trunk lid.
>
> 73
> Dale, kg5u
> >
> > Fiberglass body and all...I am not excited about drilling a
> > hole in the body anywhere for an antenna.
> >
> > So..my question is: How do I go about installing an antenna
> > on the car for my 2 meter/440 Kenwood radio? (TM-D710A)
> >
> > I forsee a noise (RFI) issue, as well as a ground plane
> > issue. I am fairly confident that I can handle the noise,
> > but the ground plane...
> >
> > Hmmmmmmm.
> >
> > Any thoughts? Or anyone who is experienced in these type of
> > fiberglass body installs that someone here could recommend to me?
> >
> > Many thanks in advance!
>
>
> _______________________________________________
> RFI mailing list
> RFI@contesting.com
> http://lists.contesting.com/mailman/listinfo/rfi
> _______________________________________________
> RFI mailing list
> RFI@contesting.com
> http://lists.contesting.com/mailman/listinfo/rfi
>
> _______________________________________________
> RFI mailing list
> RFI@contesting.com
> http://lists.contesting.com/mailman/listinfo/rfi
>
>
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|