We just put a heated water bowl out in the chicken coop...powered from the
outlet in the cabinet at the base of the tower. OF COURSE ZAP. ZAP. ZAP. At
different intervals ..buzzing across hf... Water bowl. Fish tank. Same
deal....
Bill
Sent from my iPad
On Dec 13, 2012, at 7:37 PM, "K1TTT" <K1TTT@ARRL.NET> wrote:
> Probably something arcing. Could be anything from a bad insulator on a
> power line to a light switch, neon sign, street light, or a fish tank
> heater. First eliminate your house, turn off every breaker and watch for it
> to stop... yes, this may take a while if the noise doesn't happen regularly.
> If its not in your house then go mobile see how strong it is in the driveway
> and then go a half mile or so in each direction and note strength, again,
> this may take a while if it isn't being cooperative. Hopefully at some
> point you find it getting stronger and keep going that way until it gets
> weaker then back up and start looking for the strongest source for possible
> sources.
>
>
> David Robbins K1TTT
> e-mail: mailto:k1ttt@arrl.net
> web: http://wiki.k1ttt.net
> AR-Cluster node: 145.69MHz or telnet://k1ttt.net
>
>
> -----Original Message-----
> From: Aaron Kreider [mailto:aaron@campusactivism.org]
> Sent: Thursday, December 13, 2012 22:39
> To: rfi@contesting.com
> Subject: [RFI] Screenshots of a wideband short pulse
>
> I've got a wideband short burst noise. It is very short - maybe 1/20th of a
> second. It affects everything from roughly 0 to 20 mhz. It is weaker on
> the higher frequencies and dies out around 20 mhz. I'm getting it at random
> intervals and a range of strengths. Sometimes there are 5 in a second and
> sometimes it takes 2-3 minutes to see one.
> Typically it is 20-30 db over my noise level (3 mhz - 8 mhz - below that the
> noise level is stronger). It doesn't sound like lightning.
> Lightning lasts longer, whereas this is more of a blip noise. Could
> it be an arcing loose wire?
>
> I tested shaking the antenna to see if there is a loose connection. No luck.
>
> I tested some traffic lights nearby as well.
>
> Screenshots from my QS1R:
>
> 3.8 - 5.6 Mhz
> You can see how much higher the peak noise level is (the grey line that is
> 20 db) over my regular noise level. In the spectrum history, you can see a
> blue and green horizontal line that crosses the entire band. This is how it
> regularly looks (by contrast the faint blue line on the bottom is not the
> regular look).
> http://www.campusactivism.org/images/pulse1.jpg
>
> Another 3.8-5.6 mhz
> http://www.campusactivism.org/images/pulse2.jpg
> This shows three closely spaced pulses.
>
> A weaker version of the pulse around 7-9 mhz. I turned up the sensitivity
> of the spectrum history so that it could be seen. Again you can see how the
> pulse's peak noise level is a lot higher than the regular noise (20 db+)
> http://www.campusactivism.org/images/pulse-8mhz.jpg
>
>
> 2-4mhz
> A weak version of the pulse at this range. It can be stronger.
> (You can also see vertical lines - I think I've got a touch lamp putting out
> inteference, but it is very mild compared to this pulse).
> http://www.campusactivism.org/images/pulse-3mhz-mild.jpg
>
>
> Any ideas? Are battery chargers this random?
>
> Thanks,
>
> Aaron
> _______________________________________________
> RFI mailing list
> RFI@contesting.com
> http://lists.contesting.com/mailman/listinfo/rfi
>
> _______________________________________________
> RFI mailing list
> RFI@contesting.com
> http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|
