Still sounds to me like there is street lamp that is trying to start, is
defective, and fails to start over and over. Since the photo electric cell
is preventing the start-up during the day, your noise is only heard at
night....perhaps begins at dusk? ...you might want to make note of that.
In this area of Florida, some people have these installed over their
driveways and many, many have them over their boat docks behind their
houses. These are privately owned and the power company can't fix them for
that reason. At the request of an owner who wants a lamp but has no means to
install it, the power company will install them and bills the owners monthly
for the service. Any of these in FRONT of homes should be easy to spot,
whether they be high up or just mounted over a garage door flooding light
over the driveway, etc. It is the ones to the REAR of a house that can be a
challenge to spot. THat's my two cents.
Good luck. - Mike
-----Original Message-----
From: John Geiger
Sent: Tuesday, November 12, 2013 10:08 PM
To: Dale ; rfi@contesting.com
Subject: Re: [RFI] RFI Identification Help
I pretty much determined it isn't coming from my house. This morning I had
a little time before work, and the noise showed up again, so I turned off
all circuit breakers except for the one that the shack was on. My daughters
bedroom is on the same breaker, but I turned off all of the power strips in
her room and that turned everything off. Also turned off everything else in
the shack except for the power strip that the rig is one. That also powers
the rotor and laptop. Those things are always on and the noise isnt always
there.
It stayed on with everything off, so must be outside of my house. It went
away shortly after I did this test. It doesn't seem to be on at night, so
wonder what might run during the day with this type of cycling that wouldn't
be running at night.
73 John AF5CC
----- Original Message -----
From: "Dale" <svetanoff@earthlink.net>
To: "John Geiger" <af5cc@fidmail.com>; <rfi@contesting.com>
Sent: Monday, November 11, 2013 4:33 PM
Subject: Re: [RFI] RFI Identification Help
John,
Locating the source is usually faster than speculating as to what it might
be. Start with the usual - power the '706 with a battery supply and then
turn off power in the ENTIRE house when you are hearing the noise. If the
RFI goes away, the source is somewhere in your house and you can then
start re-applying power one circuit breaker at a time until the noise
returns. You then need to examine every device on that circuit.
If the RFI does not go away when you power down the house, then it is time
for action. You will need to take the '706 mobile or portable and start
traveling around the neighborhood, or even further. Incidentally, try
using the rig in AM mode to see if you can hear the RFI better than with
SSB. Keep us posted on how it goes.
73, Dale
WA9ENA
-----Original Message-----
From: John Geiger <af5cc@fidmail.com>
Sent: Nov 11, 2013 10:24 AM
To: rfi@contesting.com
Subject: [RFI] RFI Identification Help
I have an RFI problem that mostly shows up during the day, and affects
most
bands, although I notice it most on 15 and 12 meters as I am on those
bands
more during the day. It is a buzzing type noise that comes in around S6
or
so on my Icom 706MKII, and the NB won't do anything about it. It doesn't
show up all of the time, but comes and goes, It seems to cycle with 4
seconds on and 3 seconds off, and sometimes will cycle quicker than that.
Anyone else seen an RFI issue like this and have any idea what it might
be?
It doesn't seem to occur at night.
73 John AF5CC
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|