RFI
[Top] [All Lists]

Re: [RFI] Chasing RFI on 6M

To: <dave@nk7z.net>, <rfi@contesting.com>
Subject: Re: [RFI] Chasing RFI on 6M
From: "Leigh Sedgwick" <bipi@comcast.net>
Date: Mon, 21 Dec 2015 16:51:20 -0800
List-post: <rfi@contesting.com">mailto:rfi@contesting.com>
Absolutely agree with David.  Null is the way to go.  A switchable
attenuator is very handy as you get closer to the source.  Remember that the
null is broadside to the loop...max signal is off the ends.

Mike
K7PI



-----Original Message-----
From: RFI [mailto:rfi-bounces@contesting.com] On Behalf Of David Cole
Sent: Monday, December 21, 2015 15:09
To: rfi@contesting.com
Subject: Re: [RFI] Chasing RFI on 6M

Hi,
I would recommend a loop, and use the null, not the peak...  Much simpler to
get your headings that way.  See:
http://nk7z.net/i-have-rfi-now-what-locating-it/
in that page, I covered how I did my beam headings etc., using a loop.
Hope it helps.
--
Thanks and 73's,
For equipment, and software setups and reviews see:
www.nk7z.net

For MixW support see;
http://groups.yahoo.com/neo/groups/mixw/info
For Dopplergram information see:
http://groups.yahoo.com/neo/groups/dopplergram/info
For MM-SSTV see:
http://groups.yahoo.com/neo/groups/MM-SSTV/info


On Mon, 2015-12-21 at 15:18 -0500, Jim Miller wrote:
> I have a 10db increase in noise on 6 meters to the east as compared to 
> my west. This obviously isn't good when trying to work EU 
> terrestrially or via EME at moonrise. I have already completed a full 
> house power down test with no change noted.
> 
> I have the bits needed for a portable bandscope and a Tecsun PL-660 to 
> employ in a 6M RFI hunt but I'd like some suggestions for a 
> directional 6m antenna. My initial attempt at locating the source will 
> be from my car as it is easier to carry all the stuff for the band 
> scope in particular vs walking. I figure once I get closer the PL660 will
be my walkabout device.
> It may also be useful by itself with a directional antenna.
> 
> I'm not sure on 6m a yagi would be useful due to the size so I wonder 
> what others use? Perhaps a loop? Although bidirectional I could still 
> triangulate on the source.
> 
> I know the suggested bands for finding power line noise are higher up 
> and the Tecsun will help but for now I'd like to start where I know I 
> have the problem, i.e. 6m. I don't have 2m capability here in the 
> shack or on my rotator.
> 
> Thanks!
> 
> jim ab3cv
> _______________________________________________
> RFI mailing list
> RFI@contesting.com
> http://lists.contesting.com/mailman/listinfo/rfi

_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi

_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi

<Prev in Thread] Current Thread [Next in Thread>