RFI
[Top] [All Lists]

Re: [RFI] Samsung oven RFI update

To: Dan <w8car@buckeye-express.com>, "rfi@contesting.com" <rfi@contesting.com>
Subject: Re: [RFI] Samsung oven RFI update
From: "Hare, Ed W1RFI" <w1rfi@arrl.org>
Date: Fri, 24 Apr 2020 17:48:24 +0000
List-post: <mailto:rfi@contesting.com>
Samsung may have an actual fix. i would imagine that this is  major concern to 
them because an stove or oven that turns on unexpectedly is fire risk, whether 
it is the stovetop or oven.

________________________________
From: RFI <rfi-bounces+w1rfi=arrl.org@contesting.com> on behalf of Dan 
<w8car@buckeye-express.com>
Sent: Friday, April 24, 2020 1:42 PM
To: rfi@contesting.com <rfi@contesting.com>
Subject: [RFI] Samsung oven RFI update

Gents, I wound 10 turns of an old computer AC cord around 2 cores I had laying 
around. Not sure of their lineage but think they might be 43 or 61 mix. These 
have an ID of about 1.5 inches. I also added a bunch of snap on ferrite to the 
remaining cord.  This was for testing purposes only as it would not be a safe 
NEC approved install. The termination of one end of the cord was an wall outlet 
sans box wrapped in electrical tape

I pulled the stove out (getting pretty good at this!) and installed the jury 
rigged choke in line with the power cord.

RESULTS: Initial results show NO RFI to the stove at 100 watt level on any  
band. On 20, the worst offender, I could get up to about 1KW before the oven 
began to fault. All other bands seemed to be fine at full power.

Next steps: I ordered some of the Fair rite 2631814002 31 mix toroids from 
Newark on line. These have a 3 inch ID to allow winding cord easily. They 
seemed to have the best price of any supplier at this time. When those arrive I 
will be making the MOC (mother of all chokes) up for permanent installation. I 
think with the right material and careful planning the problem should be under 
control.

I am still going to contact Samsung so they have a record of the problem if 
anything further happens or the oven craps out unexpectedly.

Once again, Thanks to all, especially W1VLF of the ARRL, for his call and 
advice.

I will keep the list posted when I get the new choke installed – hopefully a 
success story!

73
Dan W8CAR

Socially distancing but reaching out via the ether
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi

<Prev in Thread] Current Thread [Next in Thread>